A- Thread length: 6.5 mm (0.26 inch) B- Total shaft length is 18 mm (0.71 inch) Measure the thread shaft of your old clock mechanism, if the length is shorter or equal to 6 mm, then this clock movement mechanism is suitable for your clock. 1. Place metal hook over shaft.
1. Place ...A- Thread length: 6.5 mm (0.26 inch) B- Total shaft length is 18 mm (0.71 inch) Measure the thread shaft of your old clock mechanism, if the length is shorter or equal to 6 mm, then this clock movement mechanism is suitable for your clock. 1.
Place metal hook over shaft. 1. Place plastic washer over shaft.
1. Plaert shaft through clock face. 1.
Place dial plate brass washer over shaft. 1. Plaach dail fixing brass hex nut.
1. Platly press hour hand onto shaft at 12:00 postion. 1.
Place minute hand over shaft at 12:00 postion. 1. Platly screw minute nut in place.
Youngtown 12888 world renowed. High standard craftsmanship. Please compare the the holes of your own hands to shape of this clock mechanism shaft.
Recognise the Sun Logo to buy genuine. The time can be set by turning the time-set knob on the back of the clock movement. High standard craftsmanship.
Metal shaft--rounded rectangle Classic Sun Logo Setup-time Gear Fit for cross-stitch, three-dimensional embroidery, craft clock, quartz wall clock and DIY frame-less draw clock, etc. Good handwork material to make a clock by yourself. There are some clock parts made of aluminium, please do not instal them with too much pressure or they will be bent.